Repairing a ceiling after a water leak: stripping back and filling
A ceiling with brown staining and paint lifting off it after a water leak is usually a repair, not a replacement, as long as it still sits flat and feels hard when you press it. Take off the paint that has let go and fill the area in broad passes, and only then block the stain and repaint. The photos below are from two different jobs in our ceiling and plaster repairs, one stage each, not the same ceiling. Find and stop the leak first. If the water came from a bathroom above, look there, because a leak behind a wall-hung toilet can stay hidden inside the boxing until the ceiling below gives it away. Then check that the ceiling is dry to the touch, and on a moisture meter if you have one, and that the stain is no longer darkening.
Take off the paint that has let go before any filler goes on

On this ceiling the paint layer was coming away in a sheet, and we lifted it with a blade to open up the brown staining beneath, because filler and fresh paint can only hold as well as the layer they are stuck to. Along the edge above the door frame, smaller flakes were curling away and the same brown colour showed through. Brown staining like this, with paint lifting along the edge, is what water coming through a ceiling tends to leave behind. Water weakens the bond between the paint and the surface under it, and what it carries through leaves the brown mark. Paint that has let go will not stick back down.
In the photo the blade sits at the edge of the sheet, where the paint has already parted from the ceiling. Slide the blade in from the loose edge and keep working outwards until it stops going under the paint, because beyond that point the paint is still bonded and can stay. Chasing sound paint only widens the area to fill.
Press the ceiling with your fingers before you strip anything. Hard and flat under your hand means stripping and filling is the right job. If it bows or goes soft when you push, filler is the wrong fix, and the second question at the end of this post deals with that case.
Fill the ceiling in broad passes rather than dabs

On this ceiling, from a different job, the filler went on in wide patches across the surface, and a stripped area wants the same, because a broad pass flattens the step where the remaining paint stops and lets you sand the area back as one plane. You can see wide bands of filler along the cornice and through the middle, with the existing surface showing between them. Once loose paint has come off, the edge of the paint that stayed forms a small ledge around the bare patch. A dab of filler over that patch only outlines the ledge, and light coming across the ceiling from a window picks it out. So take the filler well past the stripped area and feather it out thin at the edges.
The photo stops at the filled stage, so what follows is advice. Sanding filler overhead drops fine dust onto the room below, so cover the floor and furniture first. Sand the patches flush with the surrounding ceiling, then hold a lamp close to the surface so the light rakes across it and shows up any ridge you missed. Brown staining of the kind above the door frame bleeds through water-based paint, so it takes stain-blocking primer before the finish goes on. Over the primer, paint the whole ceiling with ceiling paint, because a freshly painted patch catches the light differently from the paint around it. Painting a ceiling goes through that stage in more detail.
If your ceiling passes the press test from the section above, stripping and filling it is a job a careful DIYer can take on. If you would sooner hand it over, the same work is part of our handyman service.
Common questions about ceilings after a leak
Can you paint straight over a water stain on a ceiling?
No, emulsion on its own will not hold the mark back, because the brown colour travels up through water-based paint and reappears on the new surface. Use a primer made to block stains, and pick a solvent-based or shellac-based one, since those are the classes made to seal a stain in. Carry the primer well beyond the visible edge of the mark, as the faint outer tide line can bleed through too.
Does a water-damaged plasterboard ceiling need replacing?
If the board sags between the joists, feels soft when you press it, or its paper face is lifting off, filling will not hold and that section wants cutting out and replacing. A ceiling that is flat and firm, and has only stained and shed its paint, can usually be made good. Where a section does get replaced with new board and a skim of plaster, bear in mind that fresh plaster soaks up paint far more than the painted ceiling around it, so it needs its own preparation, such as a mist coat on new plaster, before the finish coat.




Comments