top of page

How we protect your home before we paint a single wall

Mark
Sep 19
6 min read

Before a single wall gets painted, the room gets covered, and in this kitchen polythene hangs from yellow tape at the ceiling line down over the units and the window, with the table wrapped as well. A loaded roller sheds a fine spray further than it reaches, so the cover goes on before any tin is opened, and the material on each surface depends on how that surface would be spoiled. That rule decides how decorators protect furniture and floors, and the jobs from our painting and decorating work below use cotton, polythene, paper, foil and film. Paint that dries in a hinge gap is fiddly to get out, and nobody touches the cupboards while the walls are done, so polythene hung from the ceiling tape suits a kitchen.

How decorators protect furniture that stays in the room

Upholstered bench with polythene over its back and a polythene strip on the floor below a taped skirting in a living room
The bench by the wall got polythene, while the glass table, the sofa and the plants stayed bare.

In a lived-in room the furniture usually stays, so whatever sits within reach of the wall being painted gets wrapped, because a roller throws a fine mist further than it touches, and in this living room that meant the upholstered bench by the wall, with polythene over its back. Upholstery takes a speck of emulsion into the weave, and polythene lets no mist through. The sofa and plants further from that wall were left bare, and so was the glass table, since a speck on glass wipes off. A strip of polythene on the floor below the taped skirting covers the working edge without sheeting the whole room.

Before the decorators arrive, take out what a wrap can't look after: things light enough to knock over or small enough to vanish in the folds. Clear these from around the walls being painted:

  • pictures and mirrors

  • ornaments from shelves and windowsills

  • anything fragile or sentimental

  • televisions, speakers and other electronics

Cotton where you walk, polythene where you don't

Cotton dust sheets across a cleared floor, with blue tape on the balcony door frame and yellow tape on the downlights
Cotton sheets on the open floor, with tape on the door frame, the switch and the downlights.

Cotton dust sheets go where people will be walking and polythene goes over things nobody needs to touch until the paint is dry, because cotton grips the floor and soaks up a drip while polythene seals but slides, and this flat shows the cotton half of that rule. The room had been cleared, so the sheets cover the open floor, with blue tape along the balcony door frame and its threshold, and yellow tape round the light switch and the ceiling downlights. Twill lies flat under a boot and a ladder, and a drip sinks in rather than being carried across the room.

On polythene a drop of emulsion stays wet on top, and on a hard floor the sheet can slip from under your foot. If you are laying sheets yourself, keep plastic off the route people take across the room.

Tape along the skirting and round the sockets

Yellow masking tape along the top of the skirting board, polythene on the floor and a socket taped round its edges
Tape along the skirting and round the socket, with polythene below: the line the roller must not cross.

The tape on the skirting gives the roller a hard edge to stop at, because the join between wall and skirting is where emulsion most often creeps onto the gloss, and on this job the same yellow tape went round the sockets too. Polythene covers the floor below, so anything that gets past lands on plastic. A roller can't get tight to a socket, so the wall round it is cut in by brush, and tape round its edges keeps paint off the plate. If you tape a room yourself, press the tape down with a fingernail before cutting in, since paint finds any lifted edge. The same hard-edge rule applies where the wall meets the ceiling, and you can see tape along that line in the kitchen photo this article opens with. When one colour runs over the walls, skirting and doors, as in painting a hallway in one colour, the tape moves to wherever that colour stops.

Windows, radiators and sockets get their own wrapping

Window frame taped and partly sheeted, radiator in paper, sockets and ceiling lamp in foil before the plaster was painted
Tape round the window frame, paper round the radiator and foil on the sockets and the ceiling lamp.

In this freshly plastered room the fittings got covers matched to the way paint would spoil it, which is why the radiator is in paper and the sockets are in foil. On the window, green tape runs round the frame where it meets the plaster, because spatter in the corners of a frame is fiddly to remove, and polythene covers part of the glass. The radiator's fins catch mist from the roller, and emulsion on its finish is hard to lift cleanly, so we wrapped it whole. Foil moulds to a faceplate and holds its shape with little tape, which is why it also went round the ceiling lamp. That matters more here, because on bare plaster the first coat is usually thinned (the reasons are in our piece on painting freshly plastered walls), and thinned paint throws more spray. If you cover fittings yourself, pick by shape: foil for small ones, a full wrap for anything with fins.

Stairs: self-adhesive film on the carpet

Self-adhesive protective film laid over a carpeted staircase while a decorator kneels beside it
Film over the carpeted treads, wrapped round the nosings and taped along its edges.

On a carpeted staircase a loose dust sheet is a trip waiting to happen, so this carpet got self-adhesive film that grips the pile and stays where it was laid. In the photo our decorator kneels beside the covered stairs, and blue tape holds the film's edges flat. On stairs a sheet has nothing to rest on, and a foot on the nosing drags it down to the next tread. Film holds across its whole surface, and only its edges can lift, which is why they get taped.

Door frames and windows taped, colour tested on the wall

Room under cotton dust sheets with a grey colour sample on the wall and a taped socket low on the wall
The grey tried out on the wall with the sheets down: the last check before the first full coat.

The last check before the first full coat is a sample patch of colour on the wall, because a colour on a card and the same colour in the room's own light rarely match, and in this room the grey patch went straight onto the white wall, with the sheets already down. Frames get taped as well, as on the balcony doors in the cotton-sheet photo and the window in the plastered room, because a frame takes eggshell or gloss while the wall takes matt emulsion, and that line is where a careless job shows first.

Paint on joinery also protects the timber, which is the story behind a front door we repaired rather than replaced. For your own sample, put one patch by the window and another on the darkest wall, since light from a big window flatters a shade that can look heavy in a corner.

The same room, once the sheets came off

The same flat after painting in a dusky pink, the sheets gone and the room now furnished
The flat from the cotton-sheet photo above, with the sheets off and the walls and ceiling in their new colour.

This is the flat from the cotton-sheet photo further up, shot from the same side of the room with the sheets off, and because the dusky pink runs over the ceiling as well as the walls, everything in the room sat below a roller at some stage. The room is furnished now. Rolling overhead drops more than wall work, so a room with a painted ceiling needs the open floor covered, not just a strip along each wall. The order a ceiling itself is painted in is covered in how decorators paint ceilings. Compare this photo with the cotton-sheet one at the downlights and the switch, where the tape was.

If a decorator is booked for your home, ask what they will put on your stairs and floors before they start, and see how we approach it on our painting and decorating page.

Questions about covering up before painting

Do decorators move the furniture, or do I?

Large furniture can usually stay in the room and be wrapped where it is, so you don't need to empty it. Leave enough floor in front of each wall for a step ladder to stand square, and mention any piece with a loose leg before it gets covered.

Cotton dust sheets or plastic sheeting: which is better?

Neither wins alone. On a sofa near a wall, put plastic against the upholstery and cotton over it, so a drip soaks into the cotton instead of running off the plastic.

How do you protect carpet on the stairs while painting?

Use self-adhesive carpet film rather than a loose sheet, and vacuum the carpet first, because the film grips clean pile far better than grit. When the stairwell walls are finished and dry, peel it back slowly from the top tread down.

Comments


Ready to Get Started?

​

👉 [Click Here to Contact Us] 

📧 Questions? Email us at Contactusm4@gmail.com — we’re happy to help.

Craftsmanship You Can See. Results You Can Trust.

We take pride in transforming spaces through high-quality workmanship and attention to detail. Here’s a look at some of our recent residential painting and decorating projects:

56D655D6-43C6-45E2-B3B8-68960935AD37-removebg-preview.avif

M4 Property Maintenance delivers high-quality painting, decorating, handyman services, plumbing repairs, bathroom upgrades and complete property maintenance across Virginia Water and surrounding areas.

Quick Links

Service Areas

Address

Location

Went worth Estate

Ascot

Virginia Water

Maidenhead

Windsor

Sunningdale

Sunninghill

M4 Property maintenance

Phone +447948510090

Email - contactusm4@gmail.com

​​

Privacy Policy

Cookie Policy

bottom of page