Rollers, brushes and extension poles: how we paint ceilings and doors
In these photos a grey band is rolled along the ceiling at the wall line on an extension pole, and both doors hang on their hinges with the handles still fitted while they are painted. That runs against the usual advice to cut in first and take the handles off; if you would sooner hand the job over, our painting and decorating page covers that. Each photo is one stage from one of three jobs, a room with a grey ceiling band, a hallway with an orange door and a house with white panelled doors, not one flat followed from start to finish. Whether the same approach suits your room comes down to your ceiling line and how steady your brush hand is.
Start the ceiling with a band along the wall, rolled on a pole

On this ceiling the grey went on as a band along the wall line, laid with a roller on an extension pole, because a pole holds the roller flat against that line with the same pressure from one end of the wall to the other.
In the photo the roller sits up on the band, close to the wall line, with a grey sample patch on the wall below. No brush is in sight at the ceiling line. A roller leaves an even film, and on a ceiling that matters, because light from a window skims across it and picks out brush strokes along an edge. So if a sleeve can be pressed right into the angle on your ceiling, a band rolled on the pole gives you an edge with the same texture as the open area you fill in next.
Guides on how professional decorators paint ceilings usually tell you to cut in round the edge with a brush first and roll afterwards. Keep the brush for spots where a sleeve can't sit flat, such as around a light fitting or under coving, and cut those in before you roll up to them. Along a plain wall line, try the roller first.
Pick a pole that lets the roller lie flat on the ceiling while you stand straight underneath it; if you have to lean back or stretch up on your toes, the pressure goes uneven and the band comes out patchy. Paint your own sample on a wall of the room and judge it in that light, and hold a painted card up to the ceiling as well, because a colour reads darker overhead than it does on a wall or in your hand.
Work the colour out from that band across the ceiling

At a later stage in the same room the grey band had spread well out from the wall, so the open ceiling was being filled outwards from the band, which gets the line where ceiling meets wall settled before the rush of rolling the middle.
In this photo the band reaches a long way into the ceiling above the wall with its grey sample and sockets. Fresh paint blends into the band only while the band is still wet; once that edge dries, rolling over it leaves a stripe that shows up when light comes across the ceiling. On your own ceiling, work in strips from the band outwards, with the strips running towards the window, because lap marks that run with the light throw less shadow than ones that cross it. Don't stop halfway across.
Once a coat on your ceiling has dried, look along it from below; if the old colour shows through, it needs another. If the patchy areas sit over filler or bare repairs, spot-prime those first, or they will flash through the next coat as well. In this room the floor was under polythene, since spatter from a roller overhead lands on whatever is left uncovered, and protecting the room before painting goes through that part of the job. If your ceiling is new plaster that has never been painted, the first coat is a different job, because bare plaster soaks up paint unevenly; painting new plaster explains how to handle it.
Brush a panelled door and leave the handle where it is

This panelled door is being painted with a brush while it hangs on its hinges with the lever handle still fitted, because a brush follows the mouldings round each panel and can be steered along the edge of a backplate where a roller can't go.
In the photo our decorator has the tip of the brush at a panel, the door stands slightly open on its hinges and the brass handle is still on it, with no tape over it. The mouldings round a panel are where paint gathers. A brush drags the surplus out of the corners before it can sag, while paint left sitting in the angle of a moulding creeps down and sets as a run. So on a panelled door, use a brush from edge to edge, and take the extra paint back out of each moulding with a nearly dry brush before you move on.
If you paint one yourself, this order lets each part join onto wet paint, with the stiles last in long strokes over the joints.
the edges of the door
the panels and the mouldings round them
the centre muntin, then the rails
the stiles, top to bottom
If you can steer a lightly loaded brush along the backplate without touching it, leave the handle fitted and save unscrewing it. If your hand isn't that steady, take it off, because a smear of paint on brass is harder to clean neatly than a handle is to remove.
On a flat door, paint the edges first, then fill the leaf

On this flat door both long sides were already orange while our decorator was filling the middle with a mini roller and a brush together, because the edges are where paint collects in drips and ridges, so they get sorted out before the open face goes on.
In the photo our decorator crouches at the door, mini roller pressed to the leaf in one hand, brush in the other. The strips down both long sides are already orange, there is paint round the handle and keyhole, and the middle of the leaf is still white. The lever was left uncovered; in that hallway the masking tape was on the light switch and along the floor. A roller that runs off the edge of a leaf pushes a ridge of paint onto the corner. With the edges painted first, any build-up there is laid off early, and the mini roller on the face can stop just short of the corner.
On a flat door of your own, use the mini roller for the open face, because it lays an even film that a brush can't match on a plain surface, and keep the brush for the edges and the area round the handle and lock. Tape what sits next to the door. If you are taking one colour over the walls and the woodwork, the door is painted the same way, and taking one colour over walls and doors covers how that choice plays out.
Check your own ceiling and doors against these stages and decide which you are happy to do yourself. For the rest, read more about our painting and decorating work.
Questions about painting ceilings and doors
Do you paint the ceiling or walls first?
Ceiling first, because anything that flicks off the roller lands on walls that haven't had their colour yet, and the wall colour can then be cut in cleanly under the ceiling line. Let the ceiling dry fully before you cut the wall in, so a slip of the wall brush can be touched up with ceiling paint without lifting the fresh coat.
Should you paint a panel door while it's hanging?
Both doors in these photos are being painted on their hinges, and for an interior door that is usually the better choice, since a hanging door can be worked on both faces and its edges without laying it flat and turning it over. Wedge it with a doorstop under the leaf so it doesn't swing shut against your wet edge while you work.
Is it better to paint a ceiling with a roller or a brush?
A roller, because on a wide flat surface it spreads paint without the stroke marks that catch the light, and in the first ceiling photo the band along the wall is going on with the pole-mounted roller, with no brush in sight. On a textured ceiling, pick a sleeve with a longer pile so it pushes paint down into the pattern.




Comments