top of page

Levelling clips and uncoupling mats: how tiles stay flat

Mark
Oct 15
6 min read

Each stage below has one photo, taken on at least four different jobs, so the post does not follow a single bathroom. An uncoupling mat separates the tiles from movement in the floor underneath. Tile levelling clips hold the edges of neighbouring tiles in one plane while the adhesive is soft, and a plain cross spacer only holds the width of the joint. A floor with a mat does not automatically get clips as well. If you are planning bathroom tiling and plumbing work with large tiles, your floor decides whether you need a mat, and the size and length of the tile decides between clips and plain spacers.

Uncoupling mat and levelling clips on one floor

Yellow uncoupling mat bonded to a small room floor, next to large grey floor tiles held level by clear clips and red wedges
Uncoupling mat bonded in the small room, with the first large tiles set on it and held by clips.

In this small room we set the first large tiles on a yellow uncoupling mat and held them with clips and wedges, like the tiles in the corridor outside, and one floor can have both because the mat takes up movement in the floor underneath while the clips hold each tile edge level with its neighbour.

Look at the mat around the tiles and you can see its grid texture and the grey marks of adhesive on it. A floor moves a little as it dries out or flexes under load, and a tile bonded straight to it has to follow that movement. The mat puts a layer between the two, so the floor can shift slightly without dragging the tile bed with it. Clips work on a different fault. The base of a clip sits under the edges of two tiles, and the wedge pushed through it presses both faces down to the same level while the adhesive is still soft enough to give. If your floor is new and still drying out, that is the case for asking about a mat. If it bounces underfoot, ask how it will be stiffened first, because a mat takes up small movement and does not stop a floor bending. If there is underfloor heating under your tiles, the wet and dry underfloor heating systems sit on different bases, so ask which one you have before the mat is chosen.

Plank tiles over a mat, with no clips in the joints

Wood-effect plank tiles laid in a staggered pattern over an orange uncoupling mat, joints not yet grouted
Plank tiles going down over an orange uncoupling mat; the joints stay open until grouting.

These wood-effect planks are going down in a staggered pattern over an orange uncoupling mat with no clips in the joints, and the mat under them says nothing about clips either way, because it deals with movement below the tiles and leaves the step between two planks to the tile and the layout.

The planks are long, and the mat is still showing at both sides with a grey strip lying on it. The joints are open, with no grout yet. A long tile can have a slight bow along its length, and a staggered layout puts the middle of one plank beside the end of the next, which is where that bow shows as a step. So the pattern affects how level the edges end up, whatever sits underneath. If you have chosen long plank tiles, ask which pattern and offset are planned, and ask how the edges will be kept in line while they are set.

Large wall tiles: clips stay until the adhesive holds

Large grey wall tiles with open, ungrouted joints and no clips, beside a side wall still fitted with red wedges
Main wall with open joints and no clips showing; the side wall still has clips and wedges in.

In this bathroom the side wall still has its clips and red wedges in while the main wall shows open joints and no clips, and on a wall set with clips they stay in only until the adhesive can hold each tile edge by itself, because after that the wedge has no work left to do.

The main wall is in large grey tiles with smears of adhesive still on the faces, and below the side wall a straight batten carries the bottom row of tiles over a strip not yet tiled. The photo does not show whether the main wall was set with clips, so read it as two walls at two stages. While the adhesive is soft, the clip and wedge carry the pressure that keeps two faces level. The clip then has to come out before grouting, because grout cannot fill a joint with a piece of plastic still in it. Clips should come off only once the adhesive has set hard, and each joint should be clear of broken-off pieces before any grout goes in.

Metro tiles on plain cross spacers

Blue gloss metro tiles set with white cross spacers in the joints and no levelling clips
Smaller metro tiles set with plain cross spacers: no levelling clips on this wall.

The blue metro tiles on this wall are set with plain cross spacers and no levelling clips, a common choice for small tiles because a short edge leaves little room for one tile to sit proud of the next, so keeping the joint width even does most of the work.

We used white plastic crosses and spacer pegs in the joints of this staggered gloss tile, and there is no clip or wedge on the wall. A cross spacer controls the width of the joint and does nothing for height. A short tile bends less along its edge than a long one, so a step between two of them stays small if the wall behind is flat. You can put levelling clips on metro tiles, but the gain is modest. The larger and longer your tile, the more reason there is to ask about clips. With a small format, put the question to the wall instead. Ask how flat it is and how it will be made good before the first tile goes on, because spacers will follow whatever surface they are given. If your metro tiles are meant for a kitchen splashback, a splashback panel instead of tiles is the other route, and it needs just as flat a wall.

Grouting the plank floor and sponging off the haze

Wood-effect plank floor after grouting, with sponge-wiped grout haze still on the tiles to the right
Once the joints are filled, the grout haze is sponged off before it hardens on the tile face.

The same plank floor is now grouted, with sponge marks still visible in the haze on the right, because grout haze has to come off while it is soft, and once it hardens on the tile face it takes far more effort to shift and can dull the surface.

The joints are filled in light grey. Haze is the thin film of grout left on the face of the tile after the joints are packed. Fresh, it lifts with a damp sponge. Hardened, it needs a cleaner and a lot of scrubbing. If you grout a small area yourself, work in sections you can sponge while the grout is still soft, and wring the sponge out well so it does not pull grout back out of the joints.

The finished shower, and how to check tiles yourself

Finished shower wall in large marble-effect tiles with a recessed niche, next to grouted blue metro tiles
Grouted and finished: large marble-effect tiles in the shower, with the blue metro wall alongside.

Once a shower like this one is grouted, with large marble-effect tiles around a recessed niche and the blue metro wall alongside, it is ready for your own check by fingertip and side light, because with the joints filled a tile edge that sits proud of its neighbour shows as a ridge and a thin shadow.

This looks like the same bathroom as the metro wall above, now grouted in white, with the niche framed in metal trim and two outlets ready for the shower valve. Light that rakes across a surface throws a shadow off any raised edge, and a large tile shows that shadow more clearly than a small one because its face runs unbroken for longer. Hold a torch flat against the wall and look along the joints, then run your fingertips across any joint where the shadow looks darkest. Grout set slightly below the face throws a shadow too, but only a proud edge catches your fingertip. Do this at handover, before silicone and fittings go on, and raise any joint you are unsure of there and then. Tiling is one stage of the job, and the order it takes alongside everything else is set out in a bathroom refurbishment stage by stage.

If you are weighing up large tiles for a floor or a shower, show our plumbers and tilers the floor you have and the tile you want, and ask whether it calls for a mat, clips, both or neither.

Questions about tile levelling clips and uncoupling mats

Do levelling clips flatten an uneven floor?

No, clips only pull the edges of two neighbouring tiles into line, so a hump or dip in the floor has to be dealt with before tiling starts, or the clips simply carry it across the room. Lay a long straightedge across the floor in several directions before you order tiles. If it rocks, it is sitting on a hump, and if light shows under its middle, there is a dip, so ask for either to be ground down or built up first.

Do you need levelling clips if you have an uncoupling mat?

Not because of the mat. Clips answer a separate question, which is whether your tile is long or wide enough for a step to show between neighbours. A mat also raises the finished floor slightly, so check the thresholds and door clearances when the tile choice is made.

Can you use levelling clips on walls?

Yes, large-format wall tiles take clips and wedges just as floor tiles do. On a wall the weight of a large tile pulls on the wet adhesive, so the clips keep its face in line with its neighbours while a straight batten fixed under the bottom row takes the weight until the adhesive holds.

Comments


Ready to Get Started?

​

👉 [Click Here to Contact Us] 

📧 Questions? Email us at Contactusm4@gmail.com — we’re happy to help.

Craftsmanship You Can See. Results You Can Trust.

We take pride in transforming spaces through high-quality workmanship and attention to detail. Here’s a look at some of our recent residential painting and decorating projects:

56D655D6-43C6-45E2-B3B8-68960935AD37-removebg-preview.avif

M4 Property Maintenance delivers high-quality painting, decorating, handyman services, plumbing repairs, bathroom upgrades and complete property maintenance across Virginia Water and surrounding areas.

Quick Links

Service Areas

Address

Location

Went worth Estate

Ascot

Virginia Water

Maidenhead

Windsor

Sunningdale

Sunninghill

M4 Property maintenance

Phone +447948510090

Email - contactusm4@gmail.com

​​

Privacy Policy

Cookie Policy

bottom of page